Engine Control Module: Service and Repair
REPLACEMENT1. REMOVE FRONT DOOR SCUFF PLATE RH
2. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSY NO.2
3. REMOVE GLOVE COMPARTMENT DOOR ASSY
4. REMOVE ECM
a. Remove the 2 wire harness clamps.
b. Disconnect the 5 ECM connectors.
c. Remove the 2 nuts, and then remove the ECM.
d. Remove the 2 screws, and then remove the wire harness clamp bracket.
5. REMOVE ECM BRACKET
a. Remove the 2 screws, and then remove the ECM bracket.
6. REMOVE ECM BRACKET NO.2
a. Remove the 2 screws, and then remove the ECM bracket.
7. INSTALL ECM BRACKET NO.2
8. INSTALL ECM BRACKET
9. INSTALL ECM
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
10. INSTALL GLOVE COMPARTMENT DOOR ASSY
11. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSY NO.2
12. INSTALL FRONT DOOR SCUFF PLATE RH