Inspection Procedure
- CHECK MANUAL UP/DOWN FUNCTION (REAR LH)
- Check that the power window manual UP/DOWN function operates normally.
- NG: OTHER PROBLEM (See MANUAL UP/DOWN FUNCTION DOES NOT OPERATE AT REAR LH )
- OK: Go to next step.
- CHECK LAMP OF POWER WINDOW REGULATOR SWITCH (REAR LH)
- Turn the ignition switch ON.
- Operate the power window regulator switch.
- Check the blinking pattern of the lamp as shown in Fig 2
.
- If pattern (1) is displayed, proceed to A.
- If pattern (2) or (3) is displayed, proceed to B.
- If the normal pattern is displayed, proceed to C.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- B: Go to step 4
- C: REPLACE POWER WINDOW REGULATOR SWITCH ASSY REAR (REAR LH)
- A: Go to next step.
- RESET POWER WINDOW REGULATOR MOTOR (REAR LH) (Refer to pre-check, step 16) (See PRE-CHECK
)
- NG: Go to step 4
- OK: END
- CHECK WIRE HARNESS (POWER WINDOW REGULATOR SWITCH ASSY - POWER WINDOW REGULATOR MOTOR AND BODY GROUND)
- Disconnect the P20 regulator switch connector.
- Disconnect the P25 power window motor connector.
- Check the resistance of the wire harness side connectors.
Standard:
RESISTANCE BETWEEN POWER WINDOW REGULATOR SWITCH ASSY AND POWER WINDOW REGULATOR MOTOR CONNECTOR TERMINALSTester Connection Specified Condition P20-5 (VCC) - P25-4 (SSRB) Below 1 Ω P20-3 (PLS1) - P25-5 (PLS) P20-4 (PLS2) - P25-3 (PLS2) P20-8 (SGND) - P25-6 (E) P20-5 (VCC) - Body ground 10 kΩ or higher P20-3 (PLS1) - Body ground P20-4 (PLS2) - Body ground
Fig 3: Identifying Power Window Regulator Switch And Power Window Regulator Motor Connector TerminalsCourtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- NG: REPAIR OR REPLACE HARNESS AND CONNECTOR
- OK: REPLACE POWER WINDOW REGULATOR MOTOR ASSY LH (REAR LH)