Section 452 (Audio & Visual System): Multi-Display: Replacement

HINT:

• SEE: COMPONENTS
• SEE: LOCATION .
• Installation is in the reverse order of removal.

1. SHIP MODE SETTING (SEE  RADIO RECEIVER ASSY  ) 
2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER (SEE  REPLACEMENT  ) 
3. REMOVE PANEL INSTRUMENT CLUSTER FINISH LOWER (SEE  REPLACEMENT  ) 
4. REMOVE RADIO RECEIVER ASSEMBLY W/BRACKET (SEE  RADIO RECEIVER ASSY  ) 
5. SHIP MODE CONFIRMATION (SEE  RADIO RECEIVER ASSY  ) 
   Fig 1: Removing Temperature Control Switch Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   Fig 2: Removing Instrument Cluster Finish Panel Sub-Assy Center

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   Fig 3: Removing Screws And Multi-Display

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. REMOVE TEMPERATURE CONTROL SWITCH ASSY 
   1. Disengage the 2 claws.
   2. Disconnect the connector and remove the temperature control switch assembly.
   3. Perform the same procedure on the other side.
7. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSY CENTER 
   1. Remove the 4 bolts.
   2. Disengage the 4 clips.
      NOTE: In order to prevent the safety pad from being damaged, do not pry with a screwdriver or similar tool
   3. Disconnect the connector and remove the instrument cluster finish panel sub-assy center.
8. REMOVE MULTI-DISPLAY 
   1. Remove the 4 screws and multi-display.

      HINT:

      After the replacement, perform the screen noise automatic adjustment when screen noise occurs (SEE POWER SOURCE CIRCUIT (STEREO COMPONENT AMPLIFIER ASSY) ).