Inner Rear View Mirror ASSY: Inspection

WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT INNER REAR VIEW MIRROR ASSY
1. Inspect operation of the electrochromic inner mirror.
  1. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2.
  2. Attach black colored tape to the forward sensor to prevent it from operating.
  3. Light up the mirror with an electric light, and check that the mirror surface changes from bright to dark.
  If the result is not as specified, replace the mirror assy.
  
  Fig 1: Inspecting Inner Rear View Mirror Assy
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT OUTER REAR VIEW MIRROR ASSY LH
1. Disconnect the mirror connector.
2. Apply battery voltage and inspect operation of the mirror face, as shown in Fig 3 and Fig 2 .
  
  Fig 2: Inspecting Outer Rear View Mirror Assy LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Standard (LH):

Fig 3: Outer Rear View Mirror Assy LH Table
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the result is not as specified, replace the mirror assy.
INSPECT OUTER REAR VIEW MIRROR ASSY RH
1. Disconnect the mirror connector.
2. Apply battery voltage and inspect operation of the mirror face, as shown in Fig 5 and Fig 4 .
  
  Fig 4: Inspecting Outer Rear View Mirror Assy RH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Standard (RH):

Fig 5: Outer Rear View Mirror Assy RH Table
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the result is not as specified, replace the mirror assy.