Inspection Procedure
- READ VALUE ON HAND-HELD TESTER
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch to the ON position.
- Select the item "DISP2 (MULTI MODE SW)" in the DATA LIST, and read its value on the hand-held tester.
- Check the indication displayed on the hand-held tester, when the steering pad switch (DISP2) is ON and when it is OFF.
MULTI-INFORMATION DISPLAY CONTROL SWITCH (STEERING PAD SWITCH MODULATOR):
DATA LIST (MULTI-INFORMATION DISPLAY CONTROL SWITCH (STEERING PAD SWITCH MODULATOR))Item Measurement Item / Display (Range) Normal Condition Diagnostic Note MULTI DSP2 SW Steering pad switch (DISP2) signal / ON or OFF ON <=> OFF: Change ON/OFF each time steering pad switch (DISP2) SW is pushed. - OK: When switch operation is performed the standard values will be above.
NG: REPLACE STEERING PAD SWITCH MODULATOR
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE