Steering Angle Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING ANGLE SENSOR
1. Install the steering angle sensor to the spiral cable.
  NOTE:
  - Install the claw securely.
  - Do not damage the claw.
ADJUST CENTER FRONT WHEEL
INSTALL SPIRAL CABLE (See INSTALLATION )
ADJUST SPIRAL CABLE (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (for Manual Tilt) (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (for Power Tilt and Power Telescopic) (See INSTALLATION )
INSTALL STEERING PAD (See INSTALLATION )
INSPECT STEERING WHEEL CENTER POINT
INSPECT STEERING PAD (See DISPOSAL )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
HINT:

See DIAGNOSIS SYSTEM
INSPECT ABS WARNING LIGHT AND VSC WARNING LIGHT
HINT:

See TEST MODE PROCEDURE