LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2006 >> GX 470 >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Cellular Communication) >> LEXUS Link System >> DTC 2-1; 2-2: EEPROM Communication Error; EEPROM Checksum Error >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

WARNING: This page is about a different car, the 2007 Lexus GX 470. However, it is still accessible from the selected car via links, so may be relevant.
  1. RESET MAYDAY ECU ASSEMBLY 
    1. Exit diagnosis mode and wait for 10 seconds.
    2. Disconnect the cable from the negative (-) battery terminal, and wait for 1 minute.
    3. Reconnect the cable to the negative (-) battery terminal, and wait for 10 seconds.
    4. Turn the ignition switch ON, and then check for the current DTC again.

      Result 

    RESULT REFERENCE

    Result Proceed to
    Current DTC 2-1 or 2-2 exists A
    Historic DTC 2-1 or 2-2 exists B

    B: CLEAR HISTORIC DTC 

    A: Go to next step 

  2. CHECK MAYDAY ECU ASSEMBLY 
    1. Press the "SERVICES" button and check the LEXUS Link condition with the LEXUS Link call center.

      OK: 

      System operates normally. 

      NG: 

      Current DTC 2-1 or 2-2 exists. 

      NOTE: If replacement of the ECU is necessary, replace the mayday battery (backup battery) together with the ECU. After the replacement, register the ECU (See REGISTRATION  ).

      NG: REPLACE MAYDAY ECU ASSEMBLY (See  REMOVAL   ) 

    OK: END 

scientia non olet · About LEMON Manuals