Shift Lever Assembly: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
1. Install the floor shift assembly with the 4 bolts.
  Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf)
2. Connect the 2 connectors to the floor shift assembly.
  
  Fig 1: Identifying Connector And Floor Shift Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUBASSEMBLY
1. Install the floor shift gear shifting rod sub-assembly with the nut.
  Torque: 13 N*m (133 kgf*cm, 9 ft.*lbf)
  
  Fig 2: Identifying Floor Shift Gear Shifting Rod Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR (See INSTALLATION )
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL OXYGEN SENSOR (See INSTALLATION )
INSTALL FRONT CENTER FLOOR BRACE (See INSTALLATION )
INSTALL NO. 1 REAR FLOOR PANEL BRACE (See INSTALLATION )
INSTALL NO. 2 CONSOLE BOX DUCT (See INSTALLATION )
INSTALL CONSOLE BOX (See INSTALLATION )
INSTALL CONSOLE BOX REGISTER ASSEMBLY (See INSTALLATION )
INSTALL FRONT ASH RECEPTACLE SUBASSEMBLY (See INSTALLATION )
INSTALL CONSOLE PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH (See INSTALLATION )
INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSPECT SHIFT LEVER POSITION (See ON-VEHICLE INSPECTION )
CHECK FOR EXHAUST GAS LEAKS (See INSTALLATION )