Valve Body Assembly: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION VALVE BODY ASSEMBLY
1. Install the check ball body and spring.
  NOTE: Do not drop the check ball body and spring.
  
  Fig 1: Identifying Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check the accumulator pistons, check ball body and spring as shown in the illustration.
  
  Fig 2: Checking Accumulator Pistons
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Align the groove of the manual valve with the pin of the lever.
  
  Fig 3: Aligning Groove Of Manual Valve With Pin Of Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the 20 bolts.
  Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf)
  
  Bolt length:
  - Bolt A: 36 mm (1.42 in.)
  - Bolt B: 25 mm (0.98 in.)
    
    Fig 4: Identifying Bolts
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Bolt C: 45 mm (1.77 in.)
  - Bolt D: 50 mm (1.97 in.)
CONNECT TRANSMISSION WIRE (See INSTALLATION )
INSTALL VALVE BODY OIL STRAINER ASSEMBLY (See INSTALLATION )
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY (See INSTALLATION )
ADD AUTOMATIC TRANSMISSION FLUID
(See ADJUSTMENT )
RESET MEMORY
(See HYDRAULIC TEST )