CRUISE main indicator light: Description
- The ECM detects a cruise control switch signal and sends it to the combination meter via BEAN. Then the CRUISE main indicator light comes on.
- The CRUISE main indicator light circuit uses BEAN for communication. If there is a malfunction in this circuit, check for DTCs in multiplex communication system before troubleshooting this circuit.
- PERFORM ACTIVE TEST BY INTELLIGENT TESTER
- Connect the intelligent tester to the DLC3.
- Check the CRUISE main indicator light by using ACTIVE TEST.
Combination Meter:
COMBINATION METER ACTIVE TESTItem Test Details Diagnostic Note CRUISE INDIC "CRUISE" indicator is ON/OFF - OK: Indicator light comes on / goes off.
NG : REPLACE COMBINATION METER ASSEMBLY
OK : Go to next step
- READ VALUE OF INTELLIGENT TESTER
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch on, and turn the intelligent tester main switch on.
- Check the DATA LIST for proper functioning of the CRUISE main indicator light.
Hybrid Vehicle Control ECU (Cruise Control):
HYBRID VEHICLE CONTROL ECU (CRUISE CONTROL) DATA LISTItem Measurement Item / Display (Range) Normal Condition Diagnostic Note CCS INDICATOR M Cruise indicator signal (Main CPU) / ON or OFF ON: "CCS READY" ON
OFF: "CCS READY" OFF- OK: When cruise control main switch operation is performed, the result will be same as above.
NG : REPLACE ECM
OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE