Inspection Procedure
WARNING: This page is about a different car, the 2006 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK MANUAL UP/DOWN FUNCTION (DRIVER SIDE)
- Check that the door glass can be operated manually.
NG: OTHER PROBLEM (See MANUAL UP/DOWN FUNCTION DOES NOT OPERATE ON DRIVER SIDE )
OK: GO TO NEXT STEP
- CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSY
- Turn the ignition switch ON.
- Operate the power window switch on the driver side.
- Check the blinking pattern of the illumination as shown.
- If the switch indicates (1), proceed to A.
- If the switch indicates (2) or (3), proceed to B.
- If the switch indicates normal, proceed to C.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
B: Go to step 4
C: REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSY
A: GO TO NEXT STEP
- RESET POWER WINDOW REGULATOR MOTOR (DRIVER SIDE)
- Turn the ignition switch ON.
- Open the door glass.
- Fully pull up the AUTO switch of the power window master switch until the door glass is fully closed.
- Check that the AUTO UP/DOWN function operates normally.
OK: END
NG: GO TO NEXT STEP
- CHECK WIRE HARNESS (MASTER SWITCH <==> MOTOR)
- Disconnect the D17 switch connector.
- Disconnect the P12 motor connector (driver side).
- Check the continuity between the wire harness side connectors.
Standard:
TERMINAL SPECIFIED CONDITION TABLETerminal No. Specified Condition D17-14 <==> P12-5 Continuity D17-17 <==> P12-3 Continuity D17-3 <==> P12-4 Continuity D17-2 <==> P12-6 Continuity D17-2 <==> P12-3 No continuity D17-2 <==> P12-4 No continuity D17-2 <==> P12-5 No continuity
NG: REPAIR OR REPLACE HARNESS AND CONNECTOR
OK: REPLACE POWER WINDOW REGULATOR MOTOR ASSY LH (DRIVER SIDE)