Brake Control Power Supply: Installation

INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY
1. Install the 2 brackets with the 4 bolts.
  
  Fig 1: Installing Brackets With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
2. Install the brake control power supply assembly with the 3 nuts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 2: Installing Brake Control Power Supply Assembly With Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the brake control power supply assembly connector and install the clamp.
INSTALL DECK BOARD NO.1 CHECK
1. Install the deck board No.1 check with the 4 nuts.
INSTALL DECK SIDE TRIM BOX RH
INSTALL DECK SIDE TRIM BOX LH (See INSTALLATION )
INSTALL REAR FLOOR FINISH PLATE (See INSTALLATION )
INSTALL DECK NO.2 BOARD SUB-ASSEMBLY (See INSTALLATION )
INSTALL DECK NO.3 BOARD SUB-ASSEMBLY (See INSTALLATION )

Fig 3: Installing Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DECK FLOOR BOX REAR (See INSTALLATION )
INSTALL DECK FLOOR BOX FRONT (See INSTALLATION )
INSTALL DECK BOARD SUB-ASSEMBLY (See INSTALLATION )
CHECK AND CLEAR DTC
(See DTC CHECK / CLEAR )
PERFORM INITIALIZATION
Some systems need initialization after reconnecting the cable to the negative battery terminal.

(See INITIALIZATION )