Inspection Procedure

1. Disconnect the E13 certification ECU connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection (Symbols)	Condition	Specified Condition
   E13-1 (+B1) - Body ground	Always	10 to 14 V
   E13-18 (IG) - Body ground	Engine switch OFF	Below 1 V
   	Engine switch ON (IG)	10 to 14 V
   E13-19 (ACC) - Body ground	Engine switch OFF	Below 1 V
   	Engine switch ON (ACC)	10 to 14 V

3. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection (Symbols)	Condition	Specified Condition
   E13-17 (E) - Body ground	Always	Below 1 Ω

   Fig 1: Checking Harness And Connector (Power Source Circuit)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE