Inspection Procedure
- CHECK WHETHER DTC OUTPUT RECURS (IN ADDITION TO DTC P0607)
- Connect the intelligent tester to the DLC3.
- Turn the engine switch on (IG).
- Turn the tester on.
- Clear the DTC.
- Turn the engine switch off.
- Disconnect the battery negative terminal and wait for 1 minute.
- Connect the battery negative terminal.
- Turn the engine switch on (IG).
- Enter the following menus: DIAGNOSIS / ENHANCED / DTC INFO / CURRENT CODES.
- Read the DTCs.
Result
RESULT REFERENCEDisplay (DTC output) Proceed to P0607 A No output DTC B
B: CHECK FOR INTERMITTENT PROBLEMS
A: REPLACE ECM (See REMOVAL )