Millimeter Wave Radar Sensor: Installation

INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
1. Install the millimeter wave radar sensor assembly with the 3 bolts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
2. Connect the connector.
Fig 1: Locating Millimeter Wave Radar Sensor Assembly Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT BUMPER ASSEMBLY (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADJUST MILLIMETER WAVE RADAR SENSOR (See ADJUSTMENT )
PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).
VEHICLE PREPARATION FOR FOG LIGHT AIM (See ADJUSTMENT )
PREPARATION FOR FOG LIGHT AIMING (See ADJUSTMENT )
FOG LIGHT AIMING INSPECTION (See ADJUSTMENT )
FOG LIGHT AIMING ADJUSTMENT (See REASSEMBLY )