Network Gateway Ecu: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (See AIRBAG SYSTEM ).
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See REMOVAL )
REMOVE FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure for the RH side and the LH side (See REMOVAL ).
REMOVE FRONT DOOR OPENING TRIM COVER RH
HINT:

Use the same procedure for the RH side and the LH side (See REMOVAL ).
REMOVE SIDE INSTRUMENT PANEL RH (See REMOVAL )
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE LOWER INSTRUMENT PANEL RH (See REMOVAL )
REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (See REMOVAL )
REMOVE NETWORK GATEWAY ECU
1. Remove the 2 nuts and the bolt and disengage the certification ECU with instrument panel wire.
  
  Fig 1: Identifying Network Gateway ECU Bolts And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the certification ECU with instrument panel wire in the direction indicated by the arrow.
  NOTE: Do not apply excessive force.
  
  Fig 2: Turning Certification ECU With Instrument Panel Wire
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the connector.
  
  Fig 3: Locating Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the nut and network gateway ECU.
  
  Fig 4: Locating Network Gateway ECU Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002