On-Vehicle Inspection

INSPECT STOP LIGHT CONTROL RELAY

Measure the resistance according to the value(s) in the table below.

Standard resistance

RESISTANCE SPECIFICATION

Tester Connection	Condition	Specified Condition
3 - 4	Always	Below 1 Ω
3 - 5	Always	10 kΩ or higher
3 - 4	When battery positive voltage is applied to terminal 1 and battery negative voltage to terminal 2	10 kΩ or higher
3 - 5	When battery positive voltage is applied to terminal 1 and battery negative voltage to terminal 2	Below 1 Ω

If the value is not as specified, replace the stop light control relay.

Fig 1: Identifying Stop Light Control Relay