DTC C1380/64 Stop Light Control Relay Malfunction: Description
Upon receiving the dynamic radar cruise control operating signal from the skid control ECU, the relay contact turns on and the stop light comes on.
DTC DETECTION CONDITION CHART
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1380/64 |
When either of the following is detected:
- When the voltage at the IG1 terminal is between 10 to 14 V and the stop light control relay drive output (STPO) is ON, a signal has not been input to the STP terminal for 5 seconds or more.
- When the voltage at the IG1 terminal is between 10 to 14 V and the stop light control relay drive output (STPO) is OFF, the signal at the STP1 is different from the input signal at the STP2 for 5 seconds or more.
|
- STOP fuse
- Stop light switch
- Stop light switch circuit
- Stop light control relay
- Stop light control relay circuit
- Brake actuator assembly (Skid control ECU)
|