Inspection Procedure

1. Check if the CAN communication system DTC is output (See DIAGNOSIS SYSTEM ).

   Result 

   RESULT CHART
   
   

   Condition	Proceed to
   DTC is not output	A
   DTC is output	B

B: INSPECT CAN COMMUNICATION SYSTEM 

A: Go to Next Step 

1. Connect the intelligent tester to the DLC3.
2. Start the engine.
3. Select "SLIP INDI LAMP" in the Active Test and operate the SLIP indicator light using the intelligent tester.

   ABS / VSC: 

   ABS/VSC ACTIVE TEST LIST
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   SLIP INDI LAMP	SLIP indicator light	Indicator light ON / OFF	Observe combination meter

4. Check that "ON" and "OFF" of the SLIP indicator light are indicated on the combination meter when using the intelligent tester.

   OK: 

   The SLIP indicator light turns on or off in accordance with the intelligent tester. 

   HINT:

   If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE  ).

OK: REPLACE BRAKE ACTUATOR ASSEMBLY 

NG: Go to Next Step 

1. Turn the engine switch off.
2. Perform Active Test of the combination meter (meter CPU) using the intelligent tester (See DATA LIST / ACTIVE TEST ).

   OK: 

   The SLIP indicator light turns on or off in accordance with the intelligent tester. 

   HINT:

   If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (See PROBLEM SYMPTOMS TABLE  ).

NG: REPLACE COMBINATION METER ASSEMBLY 

OK: REPLACE BRAKE ACTUATOR ASSEMBLY