Heated Oxygen Sensor: Installation

INSTALL HEATED OXYGEN SENSOR (for Bank 2)
1. Using SST, install the heated oxygen sensor.
  SST 09224-00010
  
  Torque: 44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  NOTE: The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (See REPAIR INSTRUCTION ).
  
  Fig 1: Identifying Heated Oxygen Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HEATED OXYGEN SENSOR (for Bank 1)
1. Using SST, install the heated oxygen sensor.
  SST 09224-00010
  
  Torque: 44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  NOTE: The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (See REPAIR INSTRUCTION ).
  
  Fig 2: Identifying Heated Oxygen Sensor (Bank 1)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL EXHAUST PIPE NO. 1 SUPPORT BRACKET (See INSTALLATION )
INSTALL ENGINE UNDER COVER LH
INSTALL ENGINE UNDER COVER RH