Seat Belt Control Ecu: Installation

INSTALL SEAT BELT CONTROL ECU
1. Engage the claw.
2. Engage the clip.
3. Install the seat belt control ECU with the 2 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
4. Connect the connector.
Fig 1: Identifying Seat Belt Control ECU With Bolts, Clip And Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH (See REASSEMBLY )
INSTALL REAR FLOOR FINISH PLATE (See REASSEMBLY )
INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (See REASSEMBLY )
INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (See REASSEMBLY )
INSTALL SPARE WHEEL COVER TRAY
INSTALL LUGGAGE COMPARTMENT FLOOR MAT
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )