Inspection Procedure

1. Drive the vehicle and check if operation of the speedometer in the combination meter is normal.

   HINT:

   The vehicle speed sensor is operating normally if the speedometer display is normal.

NG: CHECK SPEEDOMETER CIRCUIT 

OK: Go to Next Step 

1. Shift the lever to the neutral position.
2. Jack up the vehicle.
3. Disconnect the TCM connector.
4. Turn the engine switch on (IG).
   Fig 1: TCM Connector Terminal Identification

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Measure the voltage according to the value(s) in the table below as the wheel is turned slowly.

   Standard 

   TESTER CONNECTION AND SPECIFIED CONDITION
   
   

   Tester Connection	Specified Condition
   B40-3 (SPD1) - B40-8 (E1)	Voltage Is generated intermittently

   Fig 2: Voltage Graph

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT:

   The output voltage should fluctuate up and down similarly to the diagram when the wheel is turned slowly.

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: REPLACE TCM