Differential Oil Seal: Installation

INSTALL TRANSAXLE CASE OIL SEAL
1. Using SST and a hammer, install a new oil seal to the transaxle case.
  SST 09316-10010, 09950-70010 (09951-07100)
  
  Oil seal installation depth:
  
  -0.5 to 0.5 mm (-0.020 to 0.020 in.)
2. Coat the lip of the oil seal with MP grease.
  
  Fig 1: Installing Transaxle Case Oil Seal To Transaxle Case
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT TRANSAXLE CASE OIL SEAL
1. Using SST and a hammer, install a new oil seal to the transaxle housing.
  SST 09308-14010
  
  Oil seal installation depth:
  
  -0.5 to 0.5 mm (-0.020 to 0.020 in.)
2. Coat the lip of the oil seal with MP grease.
Fig 2: Installing Front Transaxle Case Oil Seal To Transaxle Housing
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (See INSTALLATION )
INSTALL FRONT AXLE ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT AXLE ASSEMBLY RH
HINT:

Use the same procedures described for the LH side.
INSTALL FRONT SUSPENSION LOWER NO. 1 ARM LH (See INSTALLATION )
INSTALL FRONT SUSPENSION LOWER NO. 1 ARM RH
HINT:

Use the same procedures described for the LH side.
INSTALL TIE ROD ASSEMBLY LH (See INSTALLATION )
INSTALL TIE ROD ASSEMBLY RH
HINT:

Use the same procedures described for the LH side.
INSTALL FRONT SPEED SENSOR LH (See INSTALLATION )
INSTALL FRONT SPEED SENSOR RH
INSTALL FRONT STABILIZER LINK ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:

Use the same procedures described for the LH side.
INSTALL FRONT AXLE HUB NUT LH (See INSTALLATION )
INSTALL FRONT AXLE HUB NUT RH
HINT:

Use the same procedures described for the LH side.
INSTALL FRONT WHEELS (See INSTALLATION )
ADD AUTOMATIC TRANSAXLE FLUID
HINT:

(See AUTOMATIC TRANSAXLE FLUID )
ADJUST FRONT WHEEL ALIGNMENT
HINT:

(See FRONT WHEEL ALIGNMENT )
CHECK ABS SPEED SENSOR SIGNAL
HINT:

(See TEST MODE PROCEDURE )