Oil Pump: Reassembly

INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST and a hammer, install a new oil seal to the oil pump body.
  SST 09350-32014 (09351-32140)
  
  NOTE: The seal end should be level with the outer edge of the oil pump.
2. Coat the lip of the oil seal with MP grease.
  
  Fig 1: Installing Front Oil Pump Oil Seal To Oil Pump Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new O-ring with ATF and install it to the oil pump body.
  NOTE: Ensure that the O-ring is not twisted.
  
  Fig 2: Identifying Oil Pump Body O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF and install it to the oil pump body with the marked side up.
  
  Fig 3: Identifying Front Oil Pump Driven Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side up.
  
  Fig 4: Identifying Front Oil Pump Drive Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL STATOR SHAFT ASSEMBLY

Align each knock pin of the stator shaft with the holes in the oil pump body and install the stator shaft to the oil pump body with the 16 bolts.

Using a "TORX" socket (T30), install the 11 bolts.

Torque: 9.3 N*m (95 kgf*cm, 82 in.*lbf)

BOLT LENGTH SPECIFICATION

-	Bolt length:
Bolt A	14 mm (0.55 in)
Bolt B	26 mm (1.02 in)

INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY (See INSPECTION )

Fig 5: Locating Stator Shaft Assembly Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002