Inspection Procedure

HINT:

Check that the part numbers of the installed ECM and skid control ECU are correct before performing the following procedure.

1. PERFORM INITIALIZATION OF LINEAR SOLENOID VALVE AND CALIBRATION 
   1. Clear the DTC (see DTC CHECK / CLEAR ).
   2. Perform the initialization of linear solenoid valve and calibration (see INITIALIZATION ).
2. CHECK DTC 
   1. Clear the DTC (see DTC CHECK / CLEAR ).
   2. Turn the engine switch off.
   3. Turn the engine switch on (IG).
   4. Check that the DTC (C1345/66) is recorded (see DTC CHECK / CLEAR ).

   Result 

   RESULT CHART
   
   

   Display (DTC Output)	Proceed To
   DTC (C1345/66) is not output	A
   DTC (C1345/66) is output	B (see DIAGNOSTIC TROUBLE CODE CHART )

   B: REPAIR CIRCUIT INDICATED BY OUTPUT CODE 

   A: Go to next step 

3. RECONFIRM DTC 
   1. Clear the DTC (see DTC CHECK / CLEAR ).
   2. Turn the engine switch off.
   3. Turn the engine switch on (IG).
   4. Check if the same DTC is recorded (see DTC CHECK / CLEAR ).

   Result 

   RESULT CHART
   
   

   Display (DTC Output)	Proceed To
   DTC (C1203/95) is not output	A
   DTC (C1203/95) is output	B

   B: REPLACE ECM 

   A: END