Inspection Procedure
NOTE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (see
INITIALIZATION ).
- CHECK DTC FOR VGRS SYSTEM
- Clear the DTC (see DTC CHECK / CLEAR ).
- Check for the DTC (see DTC CHECK / CLEAR ).
Result
RESULT CHARTDisplay (DTC Output) Proceed To DTC (VGRS system) is not output A DTC (VGRS system) is output B (see DIAGNOSTIC TROUBLE CODE CHART ) B: REPAIR VGRS SYSTEM ACCORDING TO DTC OUTPUT
A: Go to next step
- RECONFIRM DTC
- Clear the DTC (see DTC CHECK / CLEAR ).
- Turn the engine switch on (IG).
- Check if the same DTC is recorded (see DTC CHECK / CLEAR ).
Result
RESULT CHARTDisplay (DTC Output) Proceed To DTC (C1289/41) is not output A DTC (C1289/41) is output B B: Go to step 1
A: END