How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the seat belt warning system.
• *: Use the intelligent tester.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)* 
   1. Use the intelligent tester to check if the Multiplex Communication System (MPX) is functioning normally.

      Result: 

      RESULT CHART
      
      

      Result	Proceed to
      MPX DTC is not output	A
      MPX DTC is output	B

   B:  Go to MULTIPLEX COMMUNICATION SYSTEM

   A: Go to next step 

4. PROBLEM SYMPTOMS TABLE 

   Result: 

   RESULT CHART
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: Go to step   7 

   A: Go to next step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. (see DATA LIST / ACTIVE TEST  )
   2. (see TERMINALS OF ECU )
   3. (see ON-VEHICLE INSPECTION )
6. REPAIR OR REPLACE 
7. CONFIRMATION TEST 

   NEXT: END