April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE FRONT ACTIVE STABILIZER RELAY (STB FR)
1. Remove the front active stabilizer relay from the luggage room No. 6 relay block.

INSPECT FRONT ACTIVE STABILIZER RELAY

Measure the resistance of the relay.

Standard resistance

RESISTANCE REFERENCE CHART

Tester Connection	Specified Condition
3 - 5	10 kΩ or higher
3 - 5	Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

If the result is not as specified, replace the front active stabilizer relay.

Fig 1: Identifying Front Active Stabilizer Relay

G05296440

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL FRONT ACTIVE STABILIZER RELAY
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.