Height Control Sensor: Installation

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR 
   1. Install the height control sensor with the 2 bolts.

      Torque: 13.5 N*m (138 kgf*cm, 10 ft.*lbf) 

      Fig 1: Locating Height Control Sensor Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Align matchmarks on the height control sensor and bracket.
   3. Install the nut.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

   4. Connect the connector.
   5. Install the rear tire.
   Fig 2: Identifying Matchmarks On Height Control Sensor And Bracket

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY FRONT 
   1. Install the height control sensor with the 2 bolts.

      Torque: 13.5 N*m (138 kgf*cm, 10 ft.*lbf) 

      Fig 3: Locating Height Control Sensor Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. 4WD:

      Install the height control sensor link with the bolt to the lower arm.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

      Fig 4: Locating Height Control Sensor Link Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. 2WD:

      Install the height control sensor link with the nut to the lower arm.

      Fig 5: Locating Height Control Sensor Link Nut (2WD)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

   4. Install the front tire.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
4. PERFORM INITIALIZATION 
   1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
5. ADJUST HEADLIGHT AIMING (See  ADJUSTMENT  )