Inspection Procedure

1. Check if the component shown by the sub-code is displayed in the check result of the other components.
   1. Check if "01-DC" is output for the other components.
   2. If "01-DC" is output for any other components, check if the same physical address is displayed.

      HINT:

      For the list of the components shown by sub-codes, refer to the table in the next step.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      "01-DC" is output and the same physical address is displayed	A
      "01-DC" is not output or the same physical address is not displayed	B

B:  Go to step  4

A: Go to next step 

1. Enter the diagnostic mode.
2. Press the "LAN Mon" switch to change to "LAN Monitor" mode.
3. Identify the component which has stored this code.

   Component table 

   COMPONENT TABLE
   
   

   Display	Component
   AUDIO H/U	Radio receiver
   DSP-AMP	Stereo component amplifier
   G/W	Gateway ECU
   EMV	Multi-display

   HINT:

   "G/W" is the component which has stored this code in the example shown in the illustration.

Fig 1: Diagnostic Tool Display - LAN Mon

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Select the component which has stored this code.

   Component table 

   COMPONENT TABLE
   
   

   Component	Proceed to
   Gateway ECU (G/W)	GATEWAY ECU COMMUNICATION ERROR
   Radio receiver (AUDIO H/U)	RADIO RECEIVER COMMUNICATION ERROR
   Stereo component amplifier (DSP-AMP)	STEREO COMPONENT AMPLIFIER COMMUNICATION ERROR
   Multi-display (EMV)	MULTI-DISPLAY COMMUNICATION ERROR

NEXT: END 

1. Clear the DTCs (see DTC CHECK / CLEAR ).

   HINT:

   If "01-DC" is output for only one component, this may not indicate a malfunction.

1. Recheck for DTCs and check if the same trouble occurs again.

   OK: 

   Malfunction disappears. 

NG:  Go to step  3

OK: END