Radio Receiver: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL NO. 2 RADIO BRACKET 
   1. Install the bracket with the 5 bolts.
   Fig 1: Locating Radio No 2 Bracket Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL NO. 1 RADIO BRACKET 
   1. Install the bracket with the 5 bolts.
      Fig 2: Locating Radio No 1 Bracket Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY 
   1. Connect the connectors.
   2. Insert the multi-display with radio receiver and attach the 2 clips on its backside.
      Fig 3: Installing Multi-Display With Radio Receiver

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Install the multi-display with radio receiver with the 4 bolts.
      Fig 4: Identifying Multi-Display With Radio Receiver Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See  INSTALLATION  ) 
5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See  INSTALLATION  ) 
6. INSTALL CONSOLE UPPER PANEL ASSEMBLY (See  INSTALLATION  ) 
7. INSTALL FRONT CONSOLE UPPER PANEL GARNISH (See  INSTALLATION  ) 
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
9. PERFORM INITIALIZATION 
   1. Perform initialization (See INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.