LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GS 430 >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel >> Rear Console Box >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Console Box: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

  1. INSTALL CONSOLE BOX 
    1. Connect the connector.
    2. Install the console box with the 4 bolts and 2 screws.
    Fig 1: Installing Console Box
    G05300362Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CONSOLE BOX REGISTER ASSEMBLY 
    1. Attach the 4 clips to install the register.
    Fig 2: Installing Console Box Register
    G05300434Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL CONSOLE BOX PLATE 
    1. Connect the connector.
    2. Attach the 4 clips to install the console box plate.
    Fig 3: Installing Console Box Plate
    G05300435Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH 
    1. Attach the 4 clips and 3 claws to install the finish panel end.
    2. Install the screw.
    Fig 4: Installing Instrument Panel Finish Panel End LH
    G05300436Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH 
    1. Attach the 3 clips and 3 claws to install the finish panel end.
    2. Install the screw.
    Fig 5: Installing Instrument Panel Finish Panel End RH
    G05300437Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL CONSOLE UPPER PANEL ASSEMBLY 
    1. Connect the connector.
    2. Attach the 9 clips to install the ash receptacle.
      Fig 6: Identifying Clips
      G05300438Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the shift lever knob and twist it in the direction indicated by the arrow.
      Fig 7: Installing Shift Lever Knob
      G05300415Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL FRONT CONSOLE UPPER PANEL GARNISH 
    1. Attach the claws to install the garnish.
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  9. PERFORM INITIALIZATION 
    NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
    Perform initialization (see INITIALIZATION ).
  10. CHECK SRS WARNING LIGHT 

    Check the SRS warning light (see DIAGNOSIS SYSTEM ).