Dismounting/Mounting Procedures: Notes

CAUTION: The tire should be dismounted from the wheel using the tire changer manufacturer's instructions. Use the following information to avoid damage during the dismounting/mounting procedures.

NOTE: The system will need to be initialized when tires are rotated; tires are replaced with tires of different pressures; tire pressure sensor and/or tire pressure monitor ECU are replaced; or when a new vehicle is delivered. Set tire pressure within the specified range before initializing. When a tire pressure sensor and/or tire pressure monitor ECU are replaced, the sensor ID must be memorized by the tire pressure monitor ECU prior to system initialization. See RESET PROCEDURES .

NOTE: If negative battery terminal is disconnected, initialize the following systems after the cable is reconnected: clearance sonar, power window, sliding roof and variable gear ratio steering. Refer to owner's manual or appropriate manufacturer service information.