Rear Acceleration Sensor: Installation

NOTE:

Do not drop the acceleration sensor. If it is dropped, replace it with a new one.

INSTALL REAR ACCELERATION SENSOR
1. Install the sensor to the bracket with the nut.
  Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf)
  
  NOTE: Avoid any impact to the sensor.
  
  Fig 1: Locating Acceleration Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR ACCELERATION SENSOR ASSEMBLY
1. Install the sensor with the bolt.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  
  NOTE: Avoid any impact to the acceleration sensor.
2. Connect the sensor connector.
3. Return the luggage compartment trim cover inner RH to its original position.
  
  Fig 2: Locating Acceleration Sensor Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT ADAPTIVE VARIABLE SUSPENSION SYSTEM
1. Inspect the adaptive variable suspension system (see DTC CHECK / CLEAR ).
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.