Inspection Procedure

1. Check that the manual door lock function operates normally.

   OK: Manual door lock function operates normally. 

NG:  GO TO POWER DOOR LOCK CONTROL SYSTEM 

OK: GO TO Next Step 

1. Check the DATA LIST for proper functioning of the driver side door courtesy switch.

   Main body ECU RH: 

   NORMAL CONDITION CHART
   
   

   Item	Measurement Item / Range (Display)	Normal Condition
   D DOR CTY SW	Driver side courtesy switch / ON or OFF	ON: Courtesy switch is pushed OFF: Courtesy switch is not pushed

   OK: ON (door courtesy switch is pushed) appears on the screen. 

NG:  GO TO LIGHTING SYSTEM

OK: GO TO Next Step 

1. Check the DATA LIST for proper functioning of the door lock position switch.

   Multiplex network master switch: 

   NORMAL CONDITION CHART
   
   

   Item	Measurement Item / Range (Display)	Normal Condition
   LOCK POS SW	Door unlock detection switch signal / ON or OFF	ON: Door is unlocked OFF: Door is locked

   OK: ON (door is unlocked) appears on the screen. 

NG:  GO TO POWER DOOR LOCK CONTROL SYSTEM 

OK: GO TO Next Step 

1. Check the DATA LIST for proper functioning of the door lock switch.

   Certification ECU: 

   NORMAL CONDITION CHART
   
   

   Item	Measurement Item / Range (Display)	Normal Condition
   D TRIGGER SW	Driver side-door lock switch / ON or OFF	ON: Lock switch is pushed OFF: Lock switch is not pushed

   OK: ON (lock switch is pushed) appears on the screen. 

NG: REPLACE FRONT DOOR HANDLE ASSEMBLY OUTSIDE LH 

OK: GO TO Next Step 

1. After replacing the multiplex network door ECU front LH with a normal one, check that the entry lock function operates normally.

   OK: Entry lock function operates normally. 

NG: REPLACE CERTIFICATION ECU 

OK: END (MULTIPLEX NETWORK DOOR ECU FRONT LH IS DEFECTIVE)