How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the power window control system.
• *: Use the intelligent tester.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   HINT:

   If the voltage is below, recharge or replace the battery before proceeding.

3. INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)* 
   1. Use the intelligent tester to check if the Multiplex Communication System (MPX) is functioning normally.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      MPX DTC is not output	A
      MPX DTC is output	B

   B:  GO TO MULTIPLEX COMMUNICATION SYSTEM

   A: GO TO Next Step 

4. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B:  GO TO step  6

   A: GO TO Next Step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. DATA LIST / ACTIVE TEST (see DATA LIST / ACTIVE TEST  )
   2. On-vehicle Inspection (see ON-VEHICLE INSPECTION  )
   3. Inspection (see INSPECTION  )
   4. Terminals of ECU (see TERMINALS OF ECU  )
6. ADJUST, REPAIR OR REPLACE 
7. CONFIRMATION TEST 
8. RESET POWER WINDOW MOTOR 
   1. If the power window switch AUTO light is blinking, reset the power window motor.

   NEXT: END