Inspection Procedure

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: GO TO Next Step 

1. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   STANDARD VOLTAGE REFERENCE
   
   

   Tester Connection	Condition	Specified Condition
   K28-7 (B) - K28-1 (GND)	Always	10 to 14 V
   K28-7 (B) - K28-2 (SGND)	Always	10 to 14 V

   Fig 1: Checking Wire Harness (Steering Lock Actuator - Battery)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (STEERING LOCK ACTUATOR - BATTERY) 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE