LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GS 450h >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Mirror >> Power Mirror Control System >> Diagnosis System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis System

  1. DESCRIPTION 
    1. Power mirror control system data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.
  2. CHECK DLC3 
    1. The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
      Fig 1: Identifying DLC3 Connector Terminals
      G04828034Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TERMINAL DESCRIPTION CHART

      Symbols (Terminals No.) Terminal Description Condition Specified Condition
      SIL (7) - SG (5) Bus "+" line During transmission Pulse generation
      BAT (16) - Body ground Battery positive Always 10 to 14 V
      CG (4) - Body ground Chassis ground Always Below 1 Ω
      SG (5) - Body ground Signal ground Always Below 1 Ω
      CANH (6) - CANL (14) CAN bus line Power switch OFF(1) 54 to 69 Ω
      CANL (14)-CG (4) HIGH-level CAN bus line Power switch OFF(1) 200 Ω or higher
      CANH (6) - CG (4) HIGH-level CAN bus line Power switch OFF(1) 200 Ω or higher
      CANL (14) - Battery positive LOW-level CAN bus line Power switch OFF(1) 6 kΩ or higher
      CANH (6) - Battery positive LOW-level CAN bus line Power switch OFF(1) 6 kΩ or higher
      NOTE:
      (1) Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors.

      If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

      HINT:

      Connect the cable of the intelligent tester (with CAN VIM) to the DLC3, turn the power switch ON (IG) and attempt to use the tester. If the screen displays UNABLE TO CONNECT TO VEHICLE, a problem exists in the vehicle side or the tester side.

      • If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
      • If communication is still not possible when the tester is connected to another vehicle, the problem is probably in the tester itself. Consult the Service Department listed in the tester's instruction manual.
        Fig 2: Connecting Cable Of Intelligent Tester (With CAN VIM) To DLC3
        G05298251Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals