On-Vehicle Inspection

1. Check that the passenger side power window and rear power windows are disabled when the window lock switch of the multiplex network master switch is pressed.
2. Check that the passenger side power window and rear power windows can be operated when the window lock switch is pressed again.

1. Check that the driver side power window operates as follows:
   Fig 1: Checking Window Lock Switch

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK: 

   SWITCH OPERATION CHART
   
   

   Condition	Master Switch	Switch Operation	Power Window
   Power switch ON (IG)	Driver side	Pulled halfway up	UP (closes)
   Power switch ON (IG)	Driver side	Pushed halfway down	DOWN (opens)

2. Check that the power windows, except the driver side power window, operate as follows:

   OK: 

   SWITCH OPERATION CHART
   
   

   Condition	Each Switch	Switch Operation	Power Window
   Power switch ON (IG) Window lock switch OFF	Front passenger side	Pulled halfway up	UP (closes)
   Power switch ON (IG) Window lock switch OFF	Front passenger side	Pushed halfway down	DOWN (opens)
   Power switch ON (IG) Window lock switch OFF	Rear LH	Pulled halfway up	UP (closes)
   Power switch ON (IG) Window lock switch OFF	Rear LH	Pushed halfway down	DOWN (opens)
   Power switch ON (IG) Window lock switch OFF	Rear RH	Pulled halfway up	UP (closes)
   Power switch ON (IG) Window lock switch OFF	Rear RH	Pushed halfway down	DOWN (opens)

1. Check that the driver side power window operates as follows:

   OK: 

   SWITCH OPERATION CHART
   
   

   Condition	Master Switch	Switch Operation	Power Window
   Power switch ON (IG)	Driver side	Pulled halfway up	AUTO UP (fully closes)
   Power switch ON (IG)	Driver side	Pushed halfway down	AUTO DOWN (fully opens)

2. Check that the power windows, except the driver side power window, operate as follows:

   OK: 

   SWITCH OPERATION CHART
   
   

   Condition	Each Switch	Switch Operation	Power Window
   Power switch ON (IG) Window lock switch OFF	Front passenger side	Pulled fully up	AUTO UP (fully closes)
   Power switch ON (IG) Window lock switch OFF	Front passenger side	Pushed fully down	AUTO DOWN (fully opens)
   Power switch ON (IG) Window lock switch OFF	Rear LH	Pulled fully up	AUTO UP (fully closes)
   Power switch ON (IG) Window lock switch OFF	Rear LH	Pushed fully down	AUTO DOWN (fully opens)
   Power switch ON (IG) Window lock switch OFF	Rear RH	Pulled fully up	AUTO UP (fully closes)
   Power switch ON (IG) Window lock switch OFF	Rear RH	Pushed fully down	AUTO DOWN (fully opens)

1. Check that the power windows, except the driver side power window, operate as follows:

   OK: 

   SWITCH OPERATION CHART
   
   

   Condition	Master Switch	Switch Operation	Power Window
   Power switch ON (IG) Window lock switch OFF	Front passenger side	Pulled halfway up	UP (closes)
   Power switch ON (IG) Window lock switch OFF	Front passenger side	Pushed halfway down	DOWN (opens)
   Power switch ON (IG) Window lock switch OFF	Rear LH	Pulled halfway up	UP (closes)
   Power switch ON (IG) Window lock switch OFF	Rear LH	Pushed halfway down	DOWN (opens)
   Power switch ON (IG) Window lock switch OFF	Rear RH	Pulled halfway up	UP (closes)
   Power switch ON (IG) Window lock switch OFF	Rear RH	Pushed halfway down	DOWN (opens)

1. Check that the power windows, except the driver side power window, operate as follows:

   OK: 

   SWITCH OPERATION CHART
   
   

   Condition	Master Switch	Switch Operation	Power Window
   Power switch ON (IG) Window lock switch OFF	Front passenger side	Pulled fully up	AUTO UP (fully closes)
   Power switch ON (IG) Window lock switch OFF	Front passenger side	Pushed fully down	AUTO DOWN (fully opens)
   Power switch ON (IG) Window lock switch OFF	Rear LH	Pulled fully up	AUTO UP (fully closes)
   Power switch ON (IG) Window lock switch OFF	Rear LH	Pushed fully down	AUTO DOWN (fully opens)
   Power switch ON (IG) Window lock switch OFF	Rear RH	Pulled fully up	AUTO UP (fully closes)
   Power switch ON (IG) Window lock switch OFF	Rear RH	Pushed fully down	AUTO DOWN (fully opens)

HINT:

The jam protection function helps prevent any parts of your body from being caught by accident between door frame and the door glass during power window operation.

1. Check that the door glass moves down approximately 50 mm (1.97 in.) immediately if something gets caught between the door frame and door glass during power window operation. However, when the opening between the door frame and the door glass is less than 200 mm (7.87 in.), the door glass continues to go down and does not stop until an opening of 200 mm (7.87 in.) is achieved.

   Operative conditions:

   • AUTO UP (all doors)
   • AUTO UP / Manual UP function after the power switch is turned off (all doors)
   • Manual UP function using the driver side door lock key cylinder
     Fig 2: Placing Thick Book Between Door Frame And Door Glass

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

PTC operation is a function that prevents overloading of the power window regulator by stopping the motor. PTC operation activates when the power window regulator switch is operated for a predetermined amount of time.

1. Pull up and hold a power window switch for more than 90 seconds. Release the switch.
2. Check that pressing the switch does not move the window.
3. Wait until 60 seconds have passed since the switch was released in the first step above. Check that pressing the switch results in normal window movement.

1. Check that all of the power windows and the sliding roof operate as follows.

   OK: 

   KEY OPERATION CHART
   
   

   Condition	Key Operation	Location / Operation
   No key is inside vehicle All doors closed	Turned left (LOCK) for more than 1.5 sec.	Driver and passenger side power windows / UP
   No key is inside vehicle All doors closed	Turned left (LOCK) for more than 2.3 sec.	Rear LH and RH power windows / UP
   No key is inside vehicle All doors closed	Turned left (LOCK) for more than 3.0 sec.	Sliding roof/CLOSED
   No key is inside vehicle All doors closed	Turned right (UNLOCK) for more than 1.5 sec.	Driver and passenger side power windows / DOWN
   No key is inside vehicle All doors closed	Turned right (UNLOCK) for more than 2.3 sec.	Rear LH and RH power windows / DOWN
   No key is inside vehicle All doors closed	Turned right (UNLOCK) for more than 3.0 sec.	Sliding roof/OPEN

1. Check that all of the power windows and the sliding roof operate as follows when operating the transmitter.

   OK: 

   TRANSMITTER OPERATION CHART
   
   

   Condition	Transmitter Operation	Location / Operation
   No key is inside vehicle All doors closed	UNLOCK switch pressed for more than 2.3 sec.	Driver and passenger side power windows / DOWN
   No key is inside vehicle All doors closed	UNLOCK switch pressed for more than 2.5 sec.	Rear LH and RH power windows / DOWN
   No key is inside vehicle All doors closed	UNLOCK switch pressed for more than 3.0 sec.	Sliding roof/OPEN

   HINT:

   As a signal to begin the operation, the wireless door lock buzzer sounds once (answer-back).

1. When both of the following conditions are fulfilled, check that the power windows can be operated after the power switch is turned OFF.
   1. No doors are opened.
   2. 43 seconds have not passed.