Brake Actuator: Disposal

DISPOSE OF BRAKE ACTUATOR ASSEMBLY
1. Using a drill, slowly make a hole at the circumference made by the center points of A and discharge the gas.
  CAUTION: Be sure to wear protective glasses as fragments may fly out due to pressure.
  
  HINT:
  - The hole may be drilled up to approximately 5 to 10 mm (0.197 to 0.394 in.) away from the point indicated by A.
  - The gas is nitrogen which is colorless, odorless, and harmless.
    
    Fig 1: Drilling Hole At Circumference Made By Center Points Of A
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002