Front Axle Hub: Installation

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. TURN POWER SWITCH OFF 
   1. Turn the power switch OFF, and check that the "READY" indicator turns off.
2. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH 
   1. Install the front axle hub and front disc brake dust cover with the 4 bolts.

      Torque: 69 N*m (700 kgf*cm, 51 ft.*lbf) 

      Fig 1: Locating Front Axle Hub Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSPECT FRONT AXLE HUB BEARING LOOSENESS (See  ON-VEHICLE INSPECTION   ) 
4. INSPECT FRONT AXLE HUB RUNOUT (See  ON-VEHICLE INSPECTION   ) 
5. INSTALL FRONT DISC  (See REASSEMBLY )
6. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH 
   1. Connect the brake caliper and caliper plates to the steering knuckle with the 2 bolts.

      Torque: 78 N*m (795 kgf*cm, 58 ft.*lbf) 

      Fig 2: Locating Brake Caliper Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      • Do not twist the front brake hose when installing the front disc brake caliper.
      • Make sure that there are no foreign objects or damage on the threads of the bolts.
      • Do not overtighten the bolts because the steering knuckle is made of aluminum and may be damaged.
7. CONNECT FRONT SPEED SENSOR CONNECTOR LH 
   NOTE: Do not twist the sensor wire.
   Fig 3: Locating Front Speed Sensor Connector LH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. INSTALL FRONT WHEEL 

   Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

9. CHECK ABS SPEED SENSOR SIGNAL  (See INSTALLATION )