Rear Console Box: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

INSTALL CONSOLE BOX
1. Connect the connector.
2. Install the console box with the 4 bolts and 2 screws.
  
  Fig 1: Identifying Console Box Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CONSOLE BOX REGISTER ASSEMBLY
1. Attach the 4 clips to install the register.
  
  Fig 2: Identifying Console Box Register Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CONSOLE BOX PLATE
1. Connect the connector.
2. Attach the 4 clips to install the console box plate.
  
  Fig 3: Identifying Console Box Plate Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL FINISH PANEL END LH
1. Attach the 4 clips and 3 claws to install the finish panel end.
2. Install the screw.
  
  Fig 4: Identifying Instrument Panel Finish Panel End Clips And Claws - LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL FINISH PANEL END RH
1. Attach the 3 clips and 3 claws to install the finish panel end.
2. Install the screw.
  
  Fig 5: Identifying Instrument Panel Finish Panel End Clips And Claws - RH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CONSOLE UPPER PANEL ASSEMBLY
1. Connect the connector.
2. Attach the 9 clips to install the console upper panel.
  
  Fig 6: Identifying Console Upper Panel Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the shift lever knob and twist it in the direction indicated by the arrow.
INSTALL FRONT CONSOLE UPPER PANEL GARNISH
1. Attach the claws to install the garnish.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM (2006/02-2006/07) ).