LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GS 450h >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Component And System Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Crankshaft Position Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Installation

  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a coat of engine oil to the O-ring of the sensor.
    2. Install the sensor with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      Fig 1: Locating Crankshaft Position Sensor And Bolt
      G05285361Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the crankshaft position sensor connector.
  2. ADJUST COMPRESSOR OIL  (See INSTALLATION )
  3. INSTALL ELECTRIC INVERTER COMPRESSOR  (See INSTALLATION )
  4. INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE  (See INSTALLATION )
  5. INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE  (See INSTALLATION )
  6. INSTALL SERVICE PLUG GRIP  (See INSTALLATION )
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  8. CHARGE REFRIGERANT  (See REPLACEMENT )
  9. WARM UP ENGINE  (See REPLACEMENT )
  10. CHECK FOR LEAKAGE OF REFRIGERANT  (See REPLACEMENT )
  11. INSTALL REAR ENGINE UNDER COVER LH 
  12. INSTALL ENGINE UNDER COVER 
  13. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  14. INSTALL V-BANK COVER (See  INSTALLATION   ) 
  15. REMOVE COOL AIR INTAKE DUCT SEAL (See  INSTALLATION   ) 
  16. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals