LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GS 450h >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Component And System Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Crankshaft Position Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE SERVICE PLUG GRIP  (See REMOVAL )
  3. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL   ) 
  4. REMOVE V-BANK COVER (See  REMOVAL   ) 
  5. REMOVE NO. 1 AIR CLEANER INLET  (See ON-VEHICLE INSPECTION )
  6. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM  (See REPLACEMENT )
  7. REMOVE ENGINE UNDER COVER 
  8. REMOVE REAR ENGINE UNDER COVER LH 
  9. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE  (See REMOVAL )
  10. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE  (See REMOVAL )
  11. REMOVE ELECTRIC INVERTER COMPRESSOR  (See REMOVAL )
  12. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
      Fig 1: Locating Crankshaft Position Sensor Connector And Bolt
      G04973878Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals