April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE FUEL RELIEF VALVE RELAY (Marking: RELIEF VLV)
1. Remove the engine room No. 1 relay block cover.
2. Remove the fuel relief valve relay from the engine room No. 1 relay block.

INSPECT FUEL RELIEF VALVE RELAY

Measure the resistance of the fuel relief valve relay.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Specified Condition
3 - 5	10 kΩ or higher
3 - 5	Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

If the resistance is not as specified, replace the relay.

Fig 1: Inspecting Fuel Relief Valve Relay

G04943935

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL FUEL RELIEF VALVE RELAY
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.