Front Seat Inner Belt Assembly: Removal

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the RH side.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
1. Using a screwdriver, detach the 2 claws and remove the front seat belt hole cover.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 1: Removing Front Seat Belt Hole Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply protective tape around the seat belt anchor cover cap to the cushion shield.
3. Using a screwdriver, detach the 2 claws and remove the seat belt anchor cover cap.
  HINT:
  
  Tape the screwdriver tip before use.
4. Using the power seat switch knob, move the seat so that the seat belt anchor bolt is revealed.
  
  Fig 2: Removing Seat Belt Anchor Cover Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the bolt and front seat outer belt anchor.
  
  Fig 3: Identifying Bolt And Front Seat Outer Belt Anchor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT SEAT ASSEMBLY
1. Operate the power seat switch knob and move the seat to the rearmost position.
2. Using a screwdriver, detach the 4 claws and remove the sent track bracket cover front inner and outer.
  HINT:
  
  Tape the screwdriver tip before use.
3. Remove the 2 bolts on the front side of the seat.
4. Operate the power seat switch knob and move the seat to the foremost position.
  
  Fig 4: Identifying Front Seat Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Using a screwdriver, detach the 4 claws and remove the seat track bracket cover rear inner and outer.
6. Remove the 2 bolts on the rear side of the seat.
7. Disconnect the connectors under the seat. Then remove the seat.
  
  Fig 5: Removing Seat Track Bracket Cover Rear Inner And Outer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT SEAT INNER BELT ASSEMBLY
1. Disconnect the connector.
2. Remove the seat belt's wire harness clamp.
3. Remove the nut and seat belt.
  
  Fig 6: Locating Front Seat Inner Belt Assembly Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002