Front Active Stabilizer Control Ecu: Installation

INSTALL FRONT ACTIVE STABILIZER CONTROL ECU
1. Connect the ECU connector.
  HINT:
  
  Connect the connector before installing the ECU.
2. Install the ECU with the bolt and 2 nuts.
  Torque: 7 N*m (71 kgf*cm, 62 in.*lbf) for nut
  
  9 N*m (92 kgf*cm, 7 in.*lbf) for bolt
3. Using the procedures below, connect the ECU connectors.
  1. Connect the ECU connector.
  2. Rotate the lever in the direction of the arrow until a "click" sound is heard.
  3. Lock the lever's lock.
4. Install the 2 ground wires to the ECU with the 2 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
5. Connect the wire harness clamp to the bracket.
INSTALL NO. 2 COOL AIR INTAKE DUCT
1. Install the intake duct with the 2 bolts.
  
  Fig 1: Locating Cool Air Intake Duct Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FENDER LINER RH
INSTALL FRONT FENDER WHEEL OPENING MOULDING RH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.