Rear Acceleration Sensor: Installation

INSTALL REAR ACCELERATION SENSOR
1. Install the sensor to the bracket with the nut.
  Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf)
  NOTE:
  - Avoid any impact to the sensor.
  - Do not drop the sensor. If it is dropped, replace it with a new one.
    
    Fig 1: Locating Rear Acceleration Sensor Bracket Nut
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR ACCELERATION SENSOR ASSEMBLY
1. Install the sensor with the bolt.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  NOTE:
  - Avoid any impact to the acceleration sensor.
  - Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
  Fig 2: Locating Rear Acceleration Sensor Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the sensor connector.
3. Return the luggage compartment trim cover inner RH to its original position.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT ADAPTIVE VARIABLE SUSPENSION SYSTEM
1. Inspect the adaptive variable suspension system (see FAIL-SAFE CHART ).
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.