Inspection Procedure

1. Disconnect the skid control ECU connector.
2. Ground terminal IND of the skid control ECU.
3. Turn the ignition switch to the ON position.
4. Check that the SLIP indicator light comes on.

   OK: SLIP indicator light comes on. 

OK: REPLACE MASTER CYLINDER SOLENOID 

NG: Go to Next Step 

1. Disconnect the combination meter connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION TABLE
   
   

   Tester Connection	Specified Condition
   S37-34 (IND) - C12-20	Below 1 Ω
   S37-34 (IND) - Body ground	10 kΩ or higher

   Fig 1: Identifying Skid Control ECU Connector S37 & Combination Meter Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (IND CIRCUIT) 

OK: Go to Next Step 

1. Check the combination meter system (See HOW TO PROCEED WITH TROUBLESHOOTING ).

NG: REPLACE COMBINATION METER ASSEMBLY 

OK: END