Combination Meter: Installation

INSTALL COMBINATION METER GLASS
1. Engage the 9 claws and install the combination meter glass.
  
  Fig 1: Identifying Combination Meter Glass Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COMBINATION METER ASSEMBLY
1. Position the combination meter assembly on the steering column as shown in the illustration.
  NOTE: Do not damage the instrument panel safety pad or combination meter assembly.
2. Connect the connectors.
  
  Fig 2: Positioning Combination Meter Assembly On Steering Column
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Engage the 2 positioning pins of the combination meter assembly.
4. Engage the 2 claws and install the combination meter assembly.
5. Remove the protective tape.
INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY (See REMOVAL )

Fig 3: Identifying Pins Of Combination Meter Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Install the 2 clips.
  
  Fig 4: Identifying Instrument Cluster Finish Panel Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the instrument cluster finish panel sub-assembly with the 2 screws.
  
  Fig 5: Identifying Screws And Instrument Cluster Finish Panel Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL SIDE INSTRUMENT PANEL LH (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM COVER LH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (w/o Illumination) (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (w/ Illumination) (See INSTALLATION )
INSTALL STEERING COLUMN COVER (for Manual Tilt and Telescopic) (See INSTALLATION )
INSTALL STEERING COLUMN COVER (for Power Tilt and Power Telescopic) (See )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).